Shortwave on UV Lamp IR Heating Tech

09751713 shortwave infrared halogen heaters

Mon, 11 May 2026 11:45:46 +0800

09751713 Shortwave Infrared Halogen Heaters: Power, Design, and Application

We built the 09751713 for engineers who need serious heat in a tight space. It’s all about delivering fast, focused energy exactly where you need it—when you need it.

Power that shows up on demand

This lamp punches at 2500W and 400V, packed into a 300mm tube. That kind of power density means it wakes up fast and hits the heat immediately. And here’s the practical part: running at higher voltage keeps the current lower for the same wattage. That cuts line losses and lets you use thinner wiring, which is a real relief when you’re squeezing everything into a crowded control panel. The 300mm length? It’s a smart compromise. Short enough to fit tight machine bays, long enough to keep filament temperature stable and output consistent.

Shortwave Replacement Lamp Halogen Heater 380mm 1000w

Wed, 06 May 2026 18:25:26 +0800

Introduction

We built this shortwave replacement lamp to be a straight swap for those halogen heaters in industrial process equipment. No compromises. No messing around. It’s a 1000W lamp that runs right off the mains. The quartz tube is 380mm long and uses an R7s base. Our whole point? When the original lamp burns out, you can pop this one in and get the same heat and cycle times back—without having to rework the fixture.

Shortwave Half White Reflector Halogen Lamp Replacement Parts

Sun, 03 May 2026 17:37:21 +0800

Introduction

We design shortwave half-white reflector halogen lamps as direct replacements for industrial heating systems. These units target process heat where you need fast response, tight focus, and stable output. The core job is delivering high-intensity infrared energy in a compact footprint, so you can keep line speeds up without reworking the entire oven or heater.

Technical Deep-Dive

Shortwave halogen lamps run hot—typically 2500W to 3000W—and that power density is why they heat quickly. You can spec them at 230V or 400V, so they match your control panel and distribution without rewiring the whole machine. The tube length is usually around 300mm, which keeps the heated zone narrow and controllable. This length keeps the optical path short, so you get a concentrated hot spot rather than a broad, diffuse glow.